Go to main content
Oracle® ZFS Storage ZS5-ES Service Manual, Release OS8.7.x

Exit Print View

Updated: August 2017
 
 

Install the Front Indicator Module


Caution

Caution  -  The front indicator module should be installed only by authorized Oracle Services personnel.


  1. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

    See Take Antistatic Measures.

  2. Unpack the replacement FIM and place it on an antistatic mat.
  3. Connect the FIM cable to the replacement FIM assembly (See Remove the Front Indicator Module [3]).
  4. Carefully lower the FIM assembly into the chassis, position it over the Phillips screw in the controller chassis, and slide it forward so all the LEDs, USB connectors, and Power On button fit into place on the controller front panel [2].
  5. Tighten the Phillips screw to secure the FIM assembly to the controller chassis [2].
  6. Position the storage drive cage cover over the controller storage drive cage so that it over hangs the front of the disk drive cage by about 1/4 inch.
  7. Install the six Phillips screws to secure the cover to the controller [1].

    There are three Phillips screws on each side of the storage drive cage.

  8. Close the controller fan door.
  9. Return the controller to operation.
    1. Return the controller to the normal rack position.

      See Returning the Controller to Operation.

    2. Reconnect the data cables to the controller and reconnect the power cords to the controller power supplies.

      See Reconnect Data Cables and Power Cords.

    3. Power on the controller.

      See Power On the Controller.

      Verify that the Power/OK status indicator is steady on.