(Optional) Assemble the QSFP Cables
If the optical QSFP cables are unassembled, you must assemble the cables before
attaching them to the switch.
Note -
The ends of the optical fiber cable and the receptacles of the transceivers
must be clean and optically clear before assembly. Do not remove the protective
caps from the optical fiber cable or the plugs from the transceivers until
instructed to do so.
-
Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See Installation Task Overview.
-
Remove the QSFP optical transceivers, and fiber optic cables from their
packaging.
-
Sort the components into groupings ready for assembly.
-
If you are assembling an InfiniBand cable or Ethernet pass-through
cable, you need two QSFP optical transceivers and a fiber optic cable.
-
If you are to assemble an Ethernet splitter cable, you will need one
QSFP optical transceiver, four SFP+ optical transceivers, and an optical
splitter cable.
-
Remove the plug from the QSFP optical transceiver.
-
Remove the cap from the MTP connector of the fiber optic cable.
-
Holding the shaft of the MTP connector, insert the MTP connector into the
receptacle of the QSFP optical transceiver.
Note -
The MPO connector and QSFP receptacle are keyed for proper fitting. There
are different types of QSFP receptacles. For example, some have a retaining
clip, shown, and some have a retaining strap.
-
Push the connector into the transceiver until it clicks.
-
Consider your next step.
-
If you are assembling an InfiniBand cable or Ethernet pass-through
cable, repeat Step 4 to
Step 7 for the
other end of the cable, and then go to Step 10.
-
If you are assembling an Ethernet splitter cable, go to Step 9.
-
Repeat from Step 4
for all QSFP optical transceivers and MTP connectors.
-
Repeat from Step 3 for all
data cables to be assembled.
-
Route the data cables.
See Route the Cables.