Connect a Serial Management Device to the SER MGT Port

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. Configure the serial management device to these parameters:

   • 9600 baud

   • 8 data bits

   • No parity

   • 1 stop bit

   • No handshake

3. Connect the SER MGT cable from the switch to the serial management device.
4. If necessary, route the SER MGT cable so that it does not interfere with other cables, with servicing the switch, or with other systems.
5. Connect the power cords.

   See Connect Power Cords.

Related Information

• Connect the SER MGT Cable

• Connect Power Cords

• Power On the Switch

• Log In to the SP (SER MGT)

• Assign a Static IP Address to the SP

• Assign a Static IP Address to the SCP

• Log In to the SP (Network Management)