Connect the RJ-45 Ethernet Cables
Use this procedure to connect RJ-45 cables to an Oracle F2 Quad Port 10GBASE-T I/O
module as well as to the switch chassis.
-
Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See Installation Task Overview.
-
Orient the RJ-45 connector to where it will connect to the switch.
For the chassis, the tab on the connector is up.
For the Oracle F2 Quad Port 10GBASE-T module, the tab on the connector is to
the right.
-
Insert the connector into the receptacle until it clicks, securing it in
place.
-
Lay the cable into a slot on the cable management comb.
-
Repeat Step 2 and
Step 3 for each
cable to be connected.
-
Consider your next task.