Run Oracle VTS Software (GUI)
You can run Oracle VTS from the GUI, as described in this procedure. If you
want to run it from the command-line interface (CLI), or TTY mode, refer to the
Oracle VTS 8.2.0 Software User's Guide at: https://docs.oracle.com/cd/E83848_01/.
-
To view the host configuration, on the main page of the GUI, click Host
Configuration.
The Host Configuration page appears, and shows the machine details such as
hostname, IP address, platform, operating system, number of CPUs, machine
type, and architecture of the machine under test.
-
Click the Back button or use the navigation link at the top of the page to
return to the main page.
-
To select a test mode, on the Test Group page, from the Test Mode menu,
select the test you want to run.
By default, the System Exerciser mode is selected.
-
To select a device to test, on the Test Group page, choose the device you
want to test from the test table, and click Enable.
-
To begin the test session, perform these steps:
-
On the Test Group page, select the test you want to run from the
test table.
-
Click Enable.
-
Click Start Tests.
All tests that are enabled start.
-
To run a particular test, disable the other tests by clicking the
check box for each test, and click Disable.
-
To start a particular test when other tests are running, select
the check box for the test, and click Enable.
-
To stop the test session, on the Test Group page, click Stop Tests to stop
all the running tests.
The test session is stopped and the Status field changes to stopping.
After all tests are stopped, the status is changed to idle.