- Use
the Oracle ILOM fault management shell to determine if the new processor module
is shown as enabled or disabled:
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
- If the output from
the fmadm faulty command shows the replacement processor module
as enabled, go to Step 2.
- If the output from the fmadm
faulty command shows the replacement processor as disabled, go to Detecting and Managing Faults to clear the PSH-detected
fault from the server.
- Verify that the OK LED is lit
on the processor module and that the Fault LED is not lit.
See Processor Module LEDs.
- Verify that the front and rear
Service Required LEDs are not lit.
See Front Panel Controls and LEDs and Rear Panel Controls and LEDs.
- Perform one of the following
tasks based on your verification results:
- If the previous
steps did not clear the fault, see Diagnostics Process.
- If Step 2 and Step 3 indicate
that no faults have been detected, then the processor module has
been replaced successfully. No further action is required.
- If you are verifying the server
after adding a second processor module, return to Server Upgrade Process.