man pages section 1M: System Administration Commands

Exit Print View

Updated: July 2014
 
 

sg_rtpg (1m)

Name

sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS command

Synopsis

sg_rtpg  [--decode]  [--help]  [--hex]  [--raw]  [--verbose]
[--version] DEVICE

Description




SG3_UTILS                                              SG_RTPG(8)



NAME
     sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS command

SYNOPSIS
     sg_rtpg  [--decode]  [--help]  [--hex]  [--raw]  [--verbose]
     [--version] DEVICE

DESCRIPTION
     Send a SCSI REPORT TARGET PORT GROUPS command to DEVICE  and
     outputs the response.

     Target  port  group  access  is  described in SPC-3 found at
     www.t10.org in section 5.8 (in rev 21c dated 2005/1/15). The
     Report  Target Port Groups command is also described in that
     document.

OPTIONS
     Arguments to long options are mandatory for short options as
     well.

     -d, --decode
          decodes  the  status  code  and asymmetric access state
          from each target port group  descriptor  returned.  The
          default action is not to decode these values.

     -h, --help
          output the usage message then exit.

     -H, --hex
          output  response in hex (rather than partially or fully
          decode it).

     -r, --raw
          output response in binary to stdout.

     -v, --verbose
          increase the level of verbosity, (i.e. debug output).

     -V, --version
          print the version string and then exit.


ATTRIBUTES
     See  attributes(5)  for  descriptions   of   the   following
     attributes:










sg3_utils-1.23      Last change: January 2007                   1






SG3_UTILS                                              SG_RTPG(8)



     +---------------+--------------------------+
     |ATTRIBUTE TYPE |     ATTRIBUTE VALUE      |
     +---------------+--------------------------+
     |Availability   | system/storage/sg3_utils |
     +---------------+--------------------------+
     |Stability      | Uncommitted              |
     +---------------+--------------------------+
NOTES
     The  Report  Target  Port Groups command should be supported
     whenever the TPGS bits in a standard  INQUIRY  response  are
     greater than zero. [View with sg_inq utility.]

EXIT STATUS
     The  exit status of sg_rtpg is 0 when it is successful. Oth-
     erwise see the sg3_utils(8) man page.

AUTHORS
     Written by Douglas Gilbert.

REPORTING BUGS
     Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT
     Copyright  (C)  2004-2007  Christophe  Varoqui  and  Douglas
     Gilbert
     This  software is distributed under a FreeBSD license. There
     is NO warranty; not even for MERCHANTABILITY or FITNESS  FOR
     A PARTICULAR PURPOSE.

SEE ALSO
     sg_inq(sg3_utils)


     This   software   was   built   from   source  available  at
     https://java.net/projects/solaris-userland.   The   original
     community       source       was       downloaded       from
     http://sg.danny.cz/sg/p/sg3_utils-1.33.tgz

     Further information about this software can be found on  the
     open        source        community        website        at
     http://sg.danny.cz/sg/sg3_utils.html.














sg3_utils-1.23      Last change: January 2007                   2