Go to main content

Sun Server X4-8 Service Manual

Exit Print View

Updated: March 2018

Install the FIM

Access this component directly from the front of the server.

Before You Begin

  1. Position the connector end of the FIM at the opening of the slot.

    Ensure that the open side (internal ribbon cable visible) of the FIM is facing upward.

    image:An illustration showing the FIM aligned with its                                 slot.
  2. To install the FIM, slide it into the slot until it locks and is flush with the front of the server.

    This locking action is accompanied by a click sound.

    image:An illustration showing the installation of the FIM.
  3. Install power supply, PSU 3. See Install a PSU.
  4. Verify that the Power OK indicator on the PSU indicator panel turns on steady after power is supplied to the server and the server is in full power mode.
  5. Clear any related component faults. For more information see Clear Hardware Fault Messages.