Sun Server X4-8 Service Manual

Remove and Install the CMOD Cover

When removing or installing the CMOD cover, always maintain component serviceability requirements with regard to static protection. To protect components from damage, always use an anti static mat and wrist strap.

Before You Begin

• Remove a CMOD

1. To remove the CMOD top cover, push the release button, slide the cover away from the front of the CMOD, and lift it off the CMOD.

   ---

   Caution  -  Component damage. CMOD components are extremely sensitive to electrostatic discharge. Wear a wrist strap and use an anti-static wrist mat.

   ---

   
   
2. To install the cover, position it over the CMOD chassis with the green button at the front.
3. Set the cover on the chassis, leaving a gap of approximately one inch (25 mm) between the lead edge of the cover and the front of the CMOD.
4. Ensure that the edges of the cover encapsulate the edges of the chassis, and that the pins in the cover are aligned with the slots in the chassis sidewall.
5. Slide the cover forward until it locks into place.
   

   This action is accompanied by a click sound.