Inbound NAT is enabled on a per Location partner basis on the Partners tab for each Location partner (see Section 2.3, “Partners”).

If Inbound NAT is enabled on a Location partner, the Corente Virtual Services Gateway will re-map the partner's User Group to the subnet that you specify. Unlike Auto Resolve NAT, this setting will re-map the addresses even if there are no address conflicts. The NATed IP addresses will only be visible by local computers; the remote computers will not know that they have been NATed.

To solve address direct conflicts between two Location partners, both partners must enable Inbound NAT for each other so that address conflicts are resolved on both sides of the application network connection.