Use the following task to remove a read cache or log device from an existing storage pool. This capability is useful when preparing for a system update that requires the removal of certain cache devices.
If a pool has cache devices on both controllers of a clustered configuration, you must perform this procedure on each controller.
To add a device to a different, existing storage pool, see Adding a Cache, Meta, or Log Device to an Existing Storage Pool (CLI).
Before You Begin
Do not perform a pool configuration operation while a disk firmware upgrade is occurring. To check if an upgrade is in progress, navigate to maintenance system updates.
hostname:configuration storage (pool0)> set pool=pool1 pool = pool1
hostname:configuration storage (pool1) verify> show ID STATUS ALLOCATION DATA LOG CACHE META RPM 0 ok custom 0 0 0/4 0/4 1.86T 1 ok custom 0 0/2 34G 0 0 15000 2 ok custom 0 0/2 34G 0/2 0 15000
hostname:configuration storage (pool1)> remove
ID "0" is the controller, and the remaining IDs are the disk shelves. In the following example, 1-log=2 removes two log devices from the first disk shelf:
hostname:configuration storage (pool1) remove> set 1-log=2 1-log = 2
This example removes one cache device from the controller:
hostname:configuration storage (pool1) remove> set 0-cache=1 0-cache = 1
hostname:configuration storage (pool1) remove> done