Understanding the Switched NEM
Switched NEM Features Overview
Installing or Replacing the Switched NEM
Verifying the Switched NEM Installation
Verify Installation With the CMM ILOM Web Interface
Verify Installation With the CMM ILOM CLI
Finish the Switched NEM Installation
Install the Fabric Expansion Module in the Server Blade
Installing or Removing SFP+ or QSFP Optical Transceiver Modules
Install an SFP+ or QSFP Optical Transceiver Module
Remove an SFP+ or QFSP Optical Transceiver Module
Managing the NEM Remotely (ILOM)
Configuring an Externally Accessible IP Address on the NEM
Connecting to the NEM ILOM Through the CMM ILOM
Configure SEFOS User Privileges
Special Considerations for RADIUS Users
Configure User Privileges for RADIUS Users
Backing Up and Restoring the ILOM and SEFOS Configuration
These topics describe the front LED indicators on the Switched NEM. See Switched NEM LEDs for the location of each of the LED indicators.
This LED indicator sensor shows the immediate state of the Locate LED on the Switched NEM. This LED helps you to locate each Switched NEM. This LED can be lit either from the CMM or by pressing the Locate button on the Switched NEM. This sensor does not generate any events.
|
This LED indicator sensor shows the power state of the NEM. This sensor does not generate any events.
|
This LED indicator is not being used at this time.
This LED indicator sensor shows the immediate state of the nem/service LED on the Switched NEM. This indicator is used to determine if there is a fault present in the Switched NEM. This sensor does not generate any events.
|