|Skip Navigation Links|
|Exit Print View|
|Sun Network QDR InfiniBand Gateway Switch HTML Document Collection for Firmware Version 2.0|
Displays links presence.
This hardware command lists the presence of links and the up-down state of the associated ports on the switch chip.� The listlinkup command also accepts these arguments:
link – Displays additional information about the links.
peer – Displays additional information about the peer ports.
internal – Displays only links between the I4 switch chip and the BridgeX chips.
all – Displays all link types.
connected – Displays only links that are connected to other nodes.
The listlinkup command is available from the /SYS/Switch_Diag, /SYS/Gateway_Mgmt, and /SYS/Fabric_Mgmt Linux shell targets of the Oracle ILOM CLI interface.
This example shows how to display link presence and associated ports with the listlinkup command.
# listlinkup Connector 0A Present <-> Switch Port 20 up (Enabled) Connector 1A Present <-> Switch Port 22 up (Enabled) Connector 2A Present <-> Switch Port 24 up (Enabled) . . . Connector 15A Not present Connector 0A-ETH Present Bridge-0-1 Port 0A-ETH-1 up (Enabled) Bridge-0-1 Port 0A-ETH-2 up (Enabled) Bridge-0-0 Port 0A-ETH-3 up (Enabled) Bridge-0-0 Port 0A-ETH-4 up (Enabled) Connector 1A-ETH Present Bridge-1-1 Port 1A-ETH-1 up (Enabled) Bridge-1-1 Port 1A-ETH-2 up (Enabled) Bridge-1-0 Port 1A-ETH-3 up (Enabled) Bridge-1-0 Port 1A-ETH-4 up (Enabled) Connector 0B Present <-> Switch Port 19 up (Enabled) Connector 1B Present <-> Switch Port 21 up (Enabled) . . . Connector 15B Not present #