How to Test the sendmail Rule Sets

To check the input and returns of the sendmail rule sets, follow these instructions.

1. Change to address test mode.

   # /usr/lib/sendmail -bt

2. Test a mail address.

   Provide the following numbers and address at the last prompt (>).

   > 3,0 mail-sraddress

   mail-address

   Use the mail address that you are testing.

3. End the session.

   Press Control-d.

The following is an example of the output from the address test mode.

% /usr/lib/sendmail -bt
ADDRESS TEST MODE (ruleset 3 NOT automatically invoked)
Enter <ruleset> <address>
> 3,0 sandy@phoenix
canonify           input: sandy @ phoenix
Canonify2          input: sandy < @ phoenix >
Canonify2        returns: sandy < @ phoenix . example . com . >
canonify         returns: sandy < @ phoenix . example . com . >
parse              input: sandy < @ phoenix . example . com . >
Parse0             input: sandy < @ phoenix . example . com . >
Parse0           returns: sandy < @ phoenix . example . com . >
ParseLocal         input: sandy < @ phoenix . example . com . >
ParseLocal       returns: sandy < @ phoenix . example . com . >
Parse1             input: sandy < @ phoenix . example . com . >
MailerToTriple     input: < mailhost . phoenix . example . com > 
     sandy < @ phoenix . example . com . >
MailerToTriple   returns: $# relay $@ mailhost . phoenix . example . com 
     $: sandy < @ phoenix . example . com . >
Parse1           returns: $# relay $@ mailhost . phoenix . example . com 
     $: sandy < @ phoenix . example . com . >
parse            returns: $# relay $@ mailhost . phoenix . example . com 
     $: sandy < @ phoenix . example . com . >