Reinstall the Server Into the Rack
If you removed the server chassis from the rack, perform these steps to reinstall it.
 | Caution - Deploy any rack anti-tilt mechanisms before installing the server into the rack. |
| Caution - The server weighs approximately 18.1 kg (40.0 lbs). Two people are required to carry the chassis and install it into the rack. |
- Push the slide-rails into the slide-rail assemblies in the rack as far as possible.
- Raise the server so that the rear ends of the mounting brackets are aligned with the slide-rail assemblies that are mounted in the rack.
- Insert the mounting brackets
into the slide-rails, and then push the server into the rack until
the mounting brackets encounter the slide-rail stops, approximately
30 cm (12 inches).
The server is now in the extended maintenance position.
NumberDescription1Inserting mounting brackets into slide-rails2Slide-rail release tab (green)3Slide-rail lock