Verify the Hard Drive Backplane
After you install a hard drive backplane, you can verify its functionality.
- Reset the hard drive backplane:
-> set /SYS/SASBP clear_fault_action=true
Are you sure you want to clear /SYS/SASBP (y/n)? y
Set 'clear_fault_action' to 'true'
- Verify that the hard drive backplane is no longer considered faulty, then return
to this procedure.
See Determine if the Hard Drive Backplane Is Faulty.
- Verify the hard drive backplane by reporting each installed drive's presence:
-> show /SYS/HDDx type
type = Hard Disk
where x is 0 to 3.