SPARC T5-1B Server Module Service Manual

Install a FEM

This procedure applies to any of the form factors of FEM cards that are supported by this server module.

1. Prepare for service.

   See Preparing for Service.

2. (If needed) Remove a FEM.

   See Remove a FEM.

3. Determine the correct set of motherboard FEM connectors for your FEM.

   See FEM Configuration.

4. Insert the FEM edge into the bracket and carefully align the FEM so that the card connects with the correct motherboard connectors (panels 1).
   
5. Lower the card and press the card into place (Panel 2).

   If the card has rubber bumpers you can press directly on them to seat the card into the connectors.

6. Consider your next step.

   • If you are finished servicing components, see Returning the Server Module to Operation.

   • If you are servicing additional components, see Component Task Reference.

Related Information

• Remove a FEM