Remove the Server Module From the Modular System
- Review
the safety and handling precautions.
See Safety Information.
Caution - When the modular system is operating, you must fill every slot with a filler panel or a server module within 60 seconds.
- Prepare the server module for removal.
- If a cable is connected to the
front of the server module, disconnect it.
Press the buttons on either side of the UCP to release the connector.
- Open both ejector arms (panel
1).
Squeeze both latches on each of the two ejector arms.
- Pull the server module out (panel 2 and panel 3).
- Close the ejector arms.
- Remove the server module from
the modular system (panel 3).
Lift the server module with two hands.
- Place the server module on an antistatic mat or surface.
- Insert a filler panel into the
empty chassis slot.
Caution - When the modular system is operating, you must fill every slot with a filler panel or a server module within 60 seconds.
- Access internal server module components.