Configure Transmission Delay

You can set the estimated time required to transmit a link-state update packet on the interface using the configuration in this section. Values are 1-1800 seconds.

This example configures VLAN 10 with a transmission delay of 5 seconds.

1. Configure OSPFv3 transmission delay through the CLI.

   SEFOS(config)# interface vlan 10
   SEFOS(config-if)# ipv6 ospf transmit-delay 5
   SEFOS(config-if)# end
   

2. Ensure that the correct transmission delay is set for the specified interface.

   SEFOS# show ipv6 ospf interface vlan 10
    
           Ospfv3  Interface  Information
    
   Interface Name: vlan10      Interface Id: 41    Area Id: 0.0.0.6
   Local Address: fe80::214:4fff:fe6c:628f         Router Id: 10.0.0.1
   Network Type: BROADCAST     Cost: 1             State: DR
   Designated Router Id: 10.0.0.1      local address: fe80::214:4fff:fe6c:628f
   Backup Designated Router Id: 10.0.0.8      local address: fe80::214:4fff:fe6c:d04d
   Transmit Delay: 5 sec        Priority: 1         IfOptions: 0x0
   Timer intervals configured:
   Hello: 10, Dead: 40, Retransmit: 5, Poll: 120
   Demand Circuit: Disable            Neighbor Probing: Disable
   Nbr Probe Retrans Limit: 10        Nbr Probe Interval: 120
   Hello due in 3 sec
   Neighbor Count is: 1
   Adjacent with neighbor 10.0.0.8