Configure Specified Interfaces To Be Passive

If you don't want to configure all interfaces to be passive, you can specify which interfaces should be passive.

This example configures VLAN 10 as a passive interface.

1. Identify the interface that should be passive and suppress routing updates.

   SEFOS(config)# interface vlan 10
   SEFOS(config-if)# ipv6 ospf passive-interface
   SEFOS(config-if)# end
   

2. View the configuration details by executing the following show command.

   SEFOS# show ipv6 ospf interface vlan 10
    
           Ospfv3  Interface  Information
    
   Interface Name: vlan10      Interface Id: 41    Area Id: 0.0.0.6
   Local Address: fe80::214:4fff:fe6c:628f         Router Id: 10.0.0.1
   Network Type: BROADCAST     Cost: 1             State: DR
   Designated Router Id: 10.0.0.1      local address: fe80::214:4fff:fe6c:628f
   Backup Designated Router Id: 0.0.0.0       local address: (null)
   Transmit Delay: 1 sec        Priority: 1         IfOptions: 0x0
   Timer intervals configured:
   Hello: 10, Dead: 40, Retransmit: 5, Poll: 120
   Demand Circuit: Disable            Neighbor Probing: Disable
   Nbr Probe Retrans Limit: 10        Nbr Probe Interval: 120
   No Hellos (Passive interface)
   Neighbor Count is: 0