Configure a Stub Area

This example configures the IP address 0.0.0.6 as a stub area in SEFOS1 (router ID 10.0.0.1).

1. Enter Global Configuration mode in SEFOS1.

   SEFOS# configure terminal
   

2. Enable OSPF globally in SEFOS1.

   SEFOS(config)# ipv6 router ospf
   

3. Configure the OSPF router ID.

   SEFOS(config-router)# router-id 10.0.0.1
   

4. Configure the desired area associated with the OSPF address range as a stub area.

   SEFOS(config-router)# area 0.0.0.6 stub
   SEFOS(config-router)# end
   

5. Ensure that the stub area is created.

   SEFOS# show ipv6 ospf areas 
    
   OSPFV3  AREA  CONFIGURATION  INFORMATION
   AreaId: 0.0.0.0                 Area Type: NORMAL AREA
   Spf Calculation: 4 (times)      Area Bdr Rtr Count: 0
   As Bdr Rtr Count: 0             Area Summary: Send Summary
    
   AreaId: 0.0.0.6                 Area Type: STUB AREA
   Spf Calculation: 4 (times)      Area Bdr Rtr Count: 0
   As Bdr Rtr Count: 0             Area Summary: Send Summary
   Stub Metric: 0x1                Stub Metric Type: 1