Configure the Default VLAN ID
This task describes how to write the VLAN ID
to the flash. This ID is used as the default VLAN ID when the switch
is restarted. Do not change the default VLAN ID when some configurations
are already saved.
- Connect
to SEFOS.
See Connect to SEFOS.
- Configure the default VLAN identifier.
- Enter Global Configuration
mode.
SEFOS-1# configure terminal
- Configure the default VLAN ID
as 10.
SEFOS-1(config)# default vlan id 10
- Exit Global Configuration mode.
SEFOS-1(config)# end
- View the default VLAN ID.
SEFOS-1# show nvram
...
Config Save IP Address : 0.0.0.0
...
Default VLAN Identifier : 10
...
Note - After you have configured the default VLAN ID, you must
restart the switch before saving any configuration.