Save the Configuration to a File

This task describes how to write the running configuration to a flash file, a startup configuration file, or a remote site.

1. Connect to SEFOS.

   See Connect to SEFOS.

2. Save the configuration that is currently running to a file.

   SEFOS-1# write startup-config
   

3. View the current restoration settings.

   SEFOS-1# show nvram
   ...
   Config Restore Option                  : Restore
   Config Save Option                     : Startup save
   ...
   

4. View the restoration status.

   SEFOS-1# show system information
   ...
   Config Restore Status             : Not Initiated
   

5. Reboot the switch to verify that the current configurations were saved properly.

   If you do not want to reboot the switch at this time, you do not have to complete the last step in this task.

6. View the restoration status after rebooting the switch.

   The Config Restore Status shows Successful after the reboot.

   SEFOS-1# show  system information
   ...
   Config Restore Status               : Successful
   

Related Information

• Configure the Name of the Configuration File

• Configuring Save Parameters

• Erase a Configuration File

• Copy a Configuration File to a Remote Location

• Copy a Configuration File From a Remote Location to Flash

• Copy a Configuration File From One Remote Location or Flash to Another Remote Location or Flash