Go to main content

Oracle® Server X6-2 Service Manual

Exit Print View

Updated: January 2018
 
 

Rear Panel Connector Locations

The following illustration shows and describes the locations of the back panel connectors. Use this information to set up the server, so that you can access diagnostic tools and manage the server during service.

image:A figure showing how to connect devices to the server back panel.
No.
Cable Port or Expansion Slot
Description
1
Power supply 0 input power
Power supply 1 input power
The server has two power supply connectors, one for each power supply.
Do not attach power cables to the power supplies until you have finished connecting the data cables to the server. The server goes into standby power mode, and the Oracle ILOM service processor initializes when the AC power cables are connected to the power source. System messages might be lost after 60 seconds if the server is not connected to a terminal, PC, or workstation.

Note -  Oracle ILOM will signal a fault on any installed power supply that is not connected to an AC power source, since it might indicate a loss of redundancy.

2
Network management port (NET MGT)
The service processor NET MGT port is the optional connection to the Oracle ILOM service processor. The NET MGT port is configured by default to use Dynamic Host Configuration Protocol (DHCP). The service processor NET MGT port uses an RJ-45 cable for a 10/100/1000BASE-T connection.
3
Serial management port (SER MGT)
The service processor SER MGT port uses an RJ-45 cable and is the default connection to the Oracle ILOM service processor. This port supports local connections to the server and only recognizes Oracle ILOM command-line interface (CLI) commands. Typically you connect a terminal or terminal emulator to this port.

Note -  This port does not support network connections.

4
Ethernet ports (NET 3, NET 2, NET 1, NET 0)
The four 10-Gigabit Ethernet ports enable you to connect the system to the network.

Note -  Ethernet ports NET2 and NET3 are nonfunctional in single-processor systems.

5, 6
USB ports (USB 0, USB 1)
The two USB ports support hot-plugging. You can connect and disconnect USB cables and peripheral devices while the server is running without affecting system operations.
7
Video port (VGA)
Use a 15-pin video cable to connect a VGA video device to the server. Optionally, you can connect to the VGA port when installing the operating system.