Install an NVMe Storage Drive In the Server
Perform this procedure to physically install an NVMe storage drive into
the server.
After you physically remove an NVMe drive from the server, wait at least
10 seconds before installing a replacement drive.
-
Remove the
replacement drive from its packaging and place the drive on
an antistatic mat.
-
If necessary, remove the drive filler panel.
-
Align the replacement drive with the drive slot.
The drive is physically addressed according to the slot in which it is
installed. It is important to install a replacement drive in the same
slot as the drive that was removed.
-
Slide the drive into the slot until the drive is fully seated.
See Install a HDD or SSD Storage Drive.
-
Close the drive latch to lock the drive in place [2].
See Install a HDD or SSD Storage Drive.