ZS5-2 Front Panel Components - The ZS5-2 controller drive slots and front panel components are shown in the following figure.
Figure 6 ZS5-2 Front Panel
|
ZS5-2 Rear Panel Components - The ZS5-2 controller PCIe slots and rear panel components are shown in the following figure.
Figure 7 ZS5-2 Rear Panel
|
Cluster Interface Card Compatibility - The ZS5-2 controller contains a Version 3 cluster interface card, which is incompatible with Version 2.
For information about how to connect cables to form a cluster, see Connecting Cluster Cables in Oracle ZFS Storage Appliance Cabling Guide.
The ZS5-2 has four RJ-45 10-Gigabit Ethernet (10GbE) network connectors, labeled NET3, NET 2, NET 1, and NET 0 (left to right) on the rear panel. The ports operate at 100 Mbits/sec, 1000 Mbit/sec, or 10-Gbits/sec. Use these ports to connect the appliance to the network.
There are two status indicators (LEDs) on each port. These indicators are visible from the rear of the controller.
|
The ZS5-2 controller has one 10/100/1000BASE-T Ethernet management domain interface, labeled NET MGT. There are two status indicators (LEDs) on this port. These indicators are visible from the rear of the controller. The service processor NET MGT port is the optional connection to the Oracle ILOM service processor. The NET MGT port is configured by default to use Dynamic Host Configuration Protocol (DHCP). The service processor NET MGT port uses an RJ-45 cable for a 10/100/1000BASE-T connection.
|
The service processor SER MGT port uses an RJ-45 cable and is the default connection to the Oracle ILOM service processor. This port supports local connections to the server and only recognizes Oracle ILOM command-line interface (CLI) commands. Typically you connect a terminal or terminal emulator to this port.
The 4x4 SAS HBA, installed in PCle slot 2 of the ZS5-2, provides connectivity to external disk shelves. The HBA ports are numbered 3-0, top to bottom, as shown in the following figure.
Figure 8 ZS5-2 4x4 SAS HBA