Remove the eUSB Drive
This is a cold-service procedure that can be performed by a customer. Power down
the server completely before performing this procedure.
![Caution Caution](graphics/electrical.gif) | Caution -
This procedure requires that you handle components that are sensitive to
electrostatic discharge. Static discharges can cause the components to
fail.
|
-
Prepare the system for service.
See Preparing for Service.
-
Remove memory risers CM0/MR0, CM0/MR2 and CM0/MR3. The eUSB drive is located
under CM0/MR2.
See Remove a Memory Riser.
-
Loosen the screw that attaches the eUSB drive to the motherboard.
Retain the screw to use with the new eUSB drive.
-
Lift the eUSB drive up to disconnect it from the motherboard.
-
Install a new eUSB drive.
See Install the eUSB Drive.