Carefully lower the FIM assembly into the chassis, position it over the
Phillips screw in the controller chassis, and slide it forward so all the
LEDs, USB connectors, and Power On button fit into place on the controller
front panel [2].
Tighten the Phillips screw to secure the FIM assembly to the controller
chassis [2].
Position the storage drive cage cover over the controller storage drive
cage so that it over hangs the front of the disk drive cage by about 1/4
inch.
Install the six Phillips screws to secure the cover to the controller
[1].
There are three Phillips screws on each side of the storage drive
cage.
Close the controller fan door.
Return the controller to operation.
Return the controller to the normal rack position.