Return the Controller to the Normal Rack Position

Language:

If the controller is in the extended maintenance position, use this procedure to return the controller to the normal rack position.

Push the controller back into the rack, as described in the following steps.
1. Simultaneously pull and hold the two green release tabs (one on each side of the slide rails on the controller) toward the front of the controller while you push the controller into the rack.
  As you push the controller into the rack, verify that the cable management arm (CMA) retracts without binding.
  
  Note - To pull a green release tab, place your finger in the center of the tab, not on the end, and apply pressure as you pull the tab toward the front of the controller.
2. Continue pushing the controller into the rack until the slide-rail locks (on the front of the controller) engage the slide-rail assemblies.
  You will hear an audible click when the controller is in the normal rack position.

If the CMA is not installed, that is, you removed it because you removed the controller completely out of the rack, install the CMA.
For installation instructions for the CMA, refer to (Optional) Install the Cable Management Arm in Oracle ZFS Storage ZS5-ES Installation Guide.

If the cables are disconnected from the rear of the controller, that is, you disconnected the cables because you removed the controller completely out of the rack, reconnect the cables.
- For instructions on reconnecting cables to the rear of the controller, see Reconnect Data Cables and Power Cords.
- For detailed information on connecting cables to the rear of the controller, refer to Oracle ZFS Storage ZS5-ES Installation Guide.