Install the Battery

1. Unpack the replacement battery.
2. Press the new battery into the battery retainer with the positive side (+) facing up (see Remove the Battery[1]).
3. If there was a PCIe card installed in the PCIe riser slot 2, reinstall it.

   See Install a PCIe Riser Into PCIe Slot 1 or 2.

4. Return the controller to operation.
   1. Install the controller top cover.

      See Install the Controller Top Cover.

   2. Close the fan door.
   3. Return the controller to the normal rack position.

      See Returning the Controller to Operation.

   4. Reconnect the power cords to the controller power supplies and reconnect the data cables.

      See Reconnect Data Cables and Power Cords.

   5. Power on the controller.

      See Power On the Controller.

      Verify that the Power/OK status indicator is steady on.

   ---

   Note -  If the service processor is configured to synchronize with a network time controller using the Network Time Protocol (NTP), the Oracle ILOM clock will be reset as soon as the controller is powered on and connected to the network; otherwise, proceed to the next step.

   ---

5. If the service processor is not configured to use NTP, do one of the following:

   • Reset the Oracle ILOM clock using the Oracle ILOM CLI or the web interface.

     For instructions, refer to the Oracle Integrated Lights Out Manager (ILOM) 3.2 Documentation Library at http://www.oracle.com/goto/ILOM/docs.

   • Use the BIOS Setup Utility to reprogram the host clock.

     For the BIOS Main menu screen that supports this procedure, refer to the Oracle X5 Series Servers Administration Guide at http://www.oracle.com/goto/x86AdminDiag/docs.