Reinstall the Controller Into the Rack
If you removed the controller chassis from the rack, perform these steps
to reinstall it.
| Caution -
Deploy any rack anti-tilt mechanisms before installing the controller into the
rack.
|
| Caution -
The controller weighs approximately 18.1 kg (40.0 lbs). Two people are
required to carry the chassis and install it into the rack.
|
-
Push the slide-rails into the slide-rail assemblies in the rack as far as
possible.
-
Raise the controller so that the rear ends of the mounting brackets are
aligned with the slide-rail assemblies that are mounted in the rack.
-
Insert the mounting brackets into the slide-rails, and then push the
controller into the rack until the mounting brackets encounter the slide-rail
stops, approximately 30 cm (12 inches).
The controller is now in the extended maintenance position.
|
|
1
|
Inserting mounting brackets into slide-rails
|
2
|
Slide-rail release tab (green)
|
3
|
Slide-rail lock
|
|