Install an NVMe Storage Drive in the Server
Perform this procedure to physically install an NVMe storage drive into the
server.
Note -
After you physically remove an NVMe drive from the server, wait at least 10
seconds before installing a replacement drive.
-
Remove the replacement drive from its packaging and place the drive on an
antistatic mat.
-
If necessary, remove the drive filler panel.
-
Align the replacement drive with the drive slot.
The drive is physically addressed according to the slot in which it is
installed. It is important to install a replacement drive in the same slot as
the drive that was removed.
-
Slide the drive into the slot until the drive is fully seated.
See Install an HDD or SSD Storage Drive.
-
Close the drive latch to lock the drive in place.