SPARC T8-4 Server Service Manual

Install the Rear I/O Module

1. Take the necessary ESD precautions.

   See Prevent ESD Damage.

2. With the levers in the extended position, insert the rear I/O module into the slot at the rear of the server.
   
3. Close the extraction levers until they click into place to fully seat the rear I/O module into the server.
   
4. Connect the cables to the appropriate ports on the rear I/O module.
5. Connect the power cords.

   See Connect Power Cords.

6. Power on the server.

   See Returning the Server to Operation.

7. Verify the rear I/O installation.

   See Verify the Rear I/O Module.

Related Information

• Rear I/O Module LEDs

• Determine if the Rear I/O Module Is Faulty

• Remove the Rear I/O Module

• Verify the Rear I/O Module

• Returning the Server to Operation