SPARC T8-4 Server Service Manual

Verify a Processor Module

1. Use the Oracle ILOM fault management shell to determine if the new processor module is shown as enabled or disabled.

   -> start /SP/faultmgmt/shell
   Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
    
   faultmgmtsp> fmadm faulty
   

   1. If the output from the fmadm faulty command shows the replacement processor module as enabled, go to Step 2.
   2. If the output from the fmadm faulty command shows the replacement processor as disabled, go to Detecting and Managing Faults to clear the PSH-detected fault from the server.
2. Verify that the OK LED is lit on the processor module and that the Fault LED is not lit.

   See Processor Module LEDs.

3. Verify that the front and rear Service Required LEDs are not lit.

   See Front Panel Controls and LEDs and Rear Panel Controls and LEDs.

4. Perform one of the following tasks based on your verification results:
   • If the previous steps did not clear the fault, see Diagnostics Process.
   • If Step 2 and Step 3 indicate that no faults have been detected, then the processor module has been replaced successfully. No further action is required.
   • If you are verifying the server after adding a second processor module, return to Server Upgrade Process.

Related Information

• Processor Module Components

• Processor Module LEDs

• Determine Which Processor Module Is Faulty

• Remove a Processor Module or Processor Filler Module

• Install a Processor Module or Processor Filler Module