Install a PCIe Card Carrier
| Caution -
This procedure requires that you handle components that are sensitive to
electrostatic discharge. This discharge can cause failure of server components.
|
Note -
Installing PCIe card carriers while the server is at the OpenBoot prompt is
not supported. The server must either be powered off, or booted into the Oracle
Solaris OS.
-
Insert the PCIe card carrier into the card cage until it stops.
| Caution -
Do not press on the PCIe back panel, or force the PCIe card carrier into
the card cage.
|
-
Close the PCIe carrier handle.
Rotate the handle up until it latches into place.
-
Reconnect the cables to the PCIe card.
-
Determine your next step:
-
Take the PCIe card online. Do one of the following:
-
Press the ATTN button. The PCIe card carrier's Power OK LED should
light, indicating that the PCIe card is online.
-
Use the Oracle Solaris hotplug command.
For example:
# hotplug enable PCIE7