Go to main content

Oracle® Server X7-2 Service Manual

Exit Print View

Updated: January 2019
 
 

Remove the Disk Backplane

  1. Prepare the server for service.
    1. Power off the server and disconnect the power cords from the power supplies.

      See Powering Down the Server.

    2. Extend the server to the maintenance position.

      See Extend the Server to the Maintenance Position.

    3. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

      See Take Antistatic Measures.

    4. Remove the server top cover.

      See Remove the Server Top Cover.

    5. Lift up the super capacitor to release the capacitor from the reclosable fasteners that secure it to the chassis.

      Set the super capacitor aside (leaving the super capacitor cable attached) until you are ready to install the replacement storage drive backplane.

  2. Pull all storage drives out far enough to disengage them from the disk backplane.

    See Remove a Storage Drive.


    Note -  It is not necessary to completely remove the storage drives from the server; simply pull them out far enough to disengage them from the disk backplane. If you do remove the storage drives from the server, record their locations so that you can reinstall them in the same locations.
  3. Disconnect the SAS cables or the NVMe cables (if present) from the disk backplane [1].
    image:Figure showing how to remove the disk backplane from the                             server.
  4. Disconnect the disk backplane data cable and the temperature sensor cable from the disk backplane [2].
  5. Disconnect the disk backplane power cable from the disk backplane [3].
  6. Using a Torx T10 screwdriver, loosen the three captive screws that secure the disk backplane to the chassis [4].
  7. Lift the backplane up and tilt it toward the rear of the server to free it from the hooks and right-side metal bracket, and lift it out of the server [5].
  8. Place the disk backplane on an antistatic mat.

Related Information