Go to main content

Oracle® Server X7-2 Service Manual

Exit Print View

Updated: April 2019
 
 

Remove the Power, FIM, Temperature Sensor, and Disk Backplane Data Cables

  1. Prepare the server for service.
    1. Power off the server and disconnect the power cords from the power supplies.

      See Powering Down the Server.

    2. Extend the server to the maintenance position.

      See Extend the Server to the Maintenance Position.

    3. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

      See Take Antistatic Measures.

    4. Remove the server top cover.

      See Remove the Server Top Cover.

  2. Remove the disk backplane power cable.
    1. Disconnect the disk backplane power cable from the motherboard by pressing the release latch on the side of the cable connector and pulling out the connector [1].
    2. Disconnect the disk backplane power cable from the disk backplane by pressing the release latch on the side of the cable connector and pulling out the connector [2].
      image:Figure showing how to remove the power, FIM, temperature                                     sensor, and disk backplane data cables.
  3. Remove the temperature sensor cable.
    1. Remove the FIM from the server.

      See Remove the Temperature Sensor.

    2. Disconnect the temperature sensor cable from the disk backplane by pulling the cable from the connector [3].
    3. Remove the temperature sensor and cable from the FIM housing, then pull the cable and sensor through the left-front chassis sidewall [4].
  4. Remove the FIM cable.
    1. Remove the FIM from the server.

      See Remove the Front LED Indicator Module

    2. Disconnect the FIM cable from the FIM by pulling the cable from the connector [5].
    3. Eject the FIM cable from the motherboard by opening both side latches on the connector [6].
  5. Remove the disk backplane data cable.
    1. Eject the disk backplane data cable from the disk backplane by opening both side latches on the connector [7].
    2. Eject the disk backplane data cable from the motherboard by opening both side latches on the connector [8].

Related Information