(Optional) Clean the PrizmMT Receptacle or Connector Ferrule
Perform this procedure when you install a PrizmMT cable.
-
Determine your first step.
-
If you are cleaning a receptacle, go to Step 2.
-
If you are cleaning a connector, go to Step 9.
-
Remove the adapter from the end of the PrizmMT cleaner.
-
Insert the cleaner tip into the receptacle.
-
Advance the feeder wheel one-eighth turn in the direction of the arrow.
-
Remove the cleaner from the receptacle and check cleanliness by looking for
any contaminants in the receptacle.
-
Repeat from Step 3 if the fibers are still dirty.
-
Replace the adapter onto the end of the PrizmMT cleaner.
-
Return to Install a Data Cable.
-
Open the lid of the adapter on the end of the PrizmMT cleaner.
-
Insert the connector into the adapter.
-
Advance the feeder wheel one-eighth turn in the direction of the arrow.
-
Remove the connector from the adapter and verify cleanliness.
-
Repeat from Step 10 if the fibers are still dirty.
-
Close the lid of the adapter on the end of the PrizmMT cleaner.
-
Return to Install a Data Cable.