Service Processor
The service processor behaves differently from other component nodes. Instead
of providing a list of components, it presents a set of network properties that
can be configured from the storage appliance. The following properties control
the behavior of the service processor network management port.
Table 7 Properties for the Service Processor Network Management Port
|
|
MAC Address
|
Hardware MAC address. This is read-only
|
IP Address Source
|
Either 'DHCP' or 'Static'. Controls whether DHCP should be
used on the interface.
|
IP Address
|
IPv4 Address, when using static IP configuration. IPv6 is
not supported.
|
Subnet
|
Dotted decimal subnet, when using static IP
configuration.
|
Default Gateway
|
IPv4 default gateway address.
|
|
Changing multiple values in conflicting ways (such as changing static IP
assignments while in DHCP mode) has undefined behavior.