Go to main content

SPARC T5-8 Server Service Manual

Exit Print View

Updated: February 2019
 
 

Install a DIMM

Before beginning this procedure, ensure that you are familiar with the information provided in these topics:

  1. Take the necessary ESD precautions.

    See Prevent ESD Damage.

  2. Ensure that you have removed the processor module if you are replacing a faulty DIMM.

    See Remove a Processor Module or Processor Filler Module.

  3. Ensure that you have removed the faulty DIMM.

    See Remove a DIMM or DIMM Filler Panel.

  4. Unpack the replacement DIMM, and place it on an antistatic mat.

    Caution

    Caution  -  If you ordered processor modules without memory to upgrade the server from a half-populated configuration to a fully-populated configuration, you must install the same size and capacity of DIMMs that are already in the existing processor modules.


  5. Ensure that the ejector tabs on the connector that will receive the DIMM are in the open position.
  6. Align the DIMM notch with the key in the connector.

    Caution

    Caution  -  Ensure that the orientation is correct. The DIMM might be damaged if the orientation is reversed.



    image:Graphic showing how to insert a DIMM onto the motherboard.
  7. Push the DIMM into the connector until the ejector tabs lock the DIMM in place.

    If the DIMM does not easily seat into the connector, check the DIMM's orientation.

  8. Determine your next step.
    • If you replaced a faulty DIMM, go to Step 9.

    • If you are upgrading the server, repeat Step 5 through Step 7 until all of the new DIMMs are installed. Then, go to Server Upgrade Process.

  9. Install the PM.

    See Install a Processor Module or Processor Filler Module.

Related Information