Verify the PCIe Card

Language:

Ensure that you have completed the following:
- Applied power to the server.
  See Connect the Power Cords.
- Started the system.
  See Power On the Server (Oracle ILOM).

Verify that the Fault LED is not lit on the PCIe card.

Verify that the System Service Required LEDs on the front panel and rear I/O module are not lit.
See Interpreting LEDs.

Verify that the System PCIe Fault LED on the front panel is not lit.
See Front Panel Controls and LEDs.

Perform one of the following tasks based on your verification results:
- If any of the LEDs are lit, see Diagnostics Process.
- If none of the LEDs are lit, go to Step 6.

Verify that the green Power LED is lit on the card that you installed.

Log in to Oracle ILOM.
See Log In to Oracle ILOM (Service).

Start the faultmgmt shell.

-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y

faultmgmtsp>

Use the fmadm faulty command to determine if the server is operating normally.
- If a fault was detected, see Diagnostics Process.
- If no fault was detected, the PCIe card was installed successfully.

At the Oracle Solaris prompt, ensure that the card is enabled.

# hotplug list -l | grep PCIE

Example:

/pci@300/pci@1/pci@0/pci@6 [PCIE1] EMPTY
/pci@340/pci@1/pci@0/pci@6 [PCIE3] ENABLED
/pci@380/pci@1/pci@0/pci@a [PCIE9] EMPTY
/pci@3c0/pci@1/pci@0/pci@e [PCIE11] EMPTY
/pci@400/pci@1/pci@0/pci@c [PCIE2] EMPTY
/pci@440/pci@1/pci@0/pci@c [PCIE4] EMPTY
/pci@480/pci@1/pci@0/pci@4 [PCIE10] EMPTY
/pci@4c0/pci@1/pci@0/pci@8 [PCIE12] EMPTY
/pci@500/pci@1/pci@0/pci@e [PCIE5] EMPTY
/pci@540/pci@1/pci@0/pci@e [PCIE7] ENABLED
/pci@580/pci@1/pci@0/pci@a [PCIE13] EMPTY
/pci@5c0/pci@1/pci@0/pci@8 [PCIE15] EMPTY
/pci@600/pci@1/pci@0/pci@8 [PCIE6] EMPTY
/pci@640/pci@1/pci@0/pci@8 [PCIE8] EMPTY
/pci@680/pci@1/pci@0/pci@4 [PCIE14] EMPTY
/pci@6c0/pci@1/pci@0/pci@4 [PCIE16] EMPTY

SPARC T5-8 Server Service Manual

Verify the PCIe Card

Related Information