Log In to the SP (SER MGT)

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. On the serial management device, press the Return or Enter key several times to synchronize the connection.

   The login prompt is displayed.

   hostname login:

   where hostname is the host name of the SP. If no host name is assigned, ORACLESP-unknown might be displayed.

3. Log in to the SP.

   hostname login: root 
   Password: changeme
   ->

   The -> prompt is displayed.

   ---

   Note -  You can change the password at a later time. Refer to the Oracle EDR InfiniBand Switch and Virtualized I/O Systems Administration Guide, changing the administrator password.

   ---

4. Consider your next task.
   • If you have a full-time SER MGT connection, go to Verify LED Status or Assign a Static IP Address to the SP.
   • If your SER MGT connection is only temporary, go to Assign a Static IP Address to the SP.

Related Information

• Retrieve the Power Cords and SER MGT Cable

• Connect the SER MGT Cable

• Connect a Serial Management Device to the SER MGT Port

• Connect the Power Cords

• Install the Air Duct Assembly

• Power On the Switch

• Assign a Static IP Address to the SP

• Assign a Static IP Address to the SCP

• Log In to the SP (Network Management)