Install the Rackmount Hardware

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. Place the long rail at the mounting location on the post at the rear of the rack.
3. Butt the flange of the cable management extender against the flange of the long rail.
   
4. Using a No. 2 Philips screwdriver, secure the assembly to the post with two M6x12 screws.
5. Repeat Step 2 through Step 4 for the other cable management extender and long rail.
6. Route the power cords.

   See Route the Power Cords.

Related Information

• Stabilize the Rack

• Install the Switch Brackets

• Assemble the Cable Management Extenders

• Prepare the Air Duct Assembly

• Install the Cage Nuts

• Route the Power Cords

• Route the SER MGT Cable

• Install the Switch

• Install the CMB