Install the Switch Brackets

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. Using a No. 1 Philips screwdriver, attach the long front brackets (with cutouts) to the front of the switch with four M3x6 flathead screws on each side.

   The flange of the long front mounting brackets points away from the switch.

   
   
3. Attach the C-channel brackets to the switch with four M3x6 flathead screws on each side.

   The edge of each C-channel bracket is flush to the rear of the chassis.

4. Assemble the cable management extenders.

   See Assemble the Cable Management Extenders.

Related Information

• Stabilize the Rack

• Assemble the Cable Management Extenders

• Prepare the Air Duct Assembly

• Install the Cage Nuts

• Install the Rackmount Hardware

• Route the Power Cords

• Route the SER MGT Cable

• Install the Switch

• Install the CMB