Go to main content

Oracle® MiniCluster S7-2 Installation Guide

Exit Print View

Updated: October 2021
 
 

Log In To Compute Node 1 (Oracle ILOM)

  1. On compute node 1, connect to the Oracle ILOM on the SP using the NET MGT port.

    Use the settings that you provided in Assign a Static IP Address to the NET MGT Port. For example, connect to the Oracle ILOM on the SP on compute node 1 by using a terminal emulator and typing:

    # ssh root@ILOM-IPaddress

    where ILOM-IPaddress is the Oracle ILOM IP address that you assigned to the service processor on the first compute node in Assign a Static IP Address to the NET MGT Port.

    Use the initial credentials (see Power On the Compute Nodes for the First Time).


    Note -  After the initial installation is complete, change the default ILOM password for both compute nodes. Refer to the Oracle MiniCluster S7-2 Administration Guide for those instructions.
  2. Connect to the host console.
    start /HOST/console

    Type y when you see the question Are you sure you want to start /HOST/console (y/n).

  3. Log in to compute node 1.

    Use the initial credentials:

    • mcinstall

    • welcome1

  4. Determine if you used the Initial Configuration tool or not when you completed the procedures in Preliminary Tasks.
    • If you used the Initial Configuration tool to complete the preliminary configuration tasks, then you have the two configuration files that were generated as part of that process.

      Go to Copy Configuration Files to Compute Node 1.

    • If you did not use the Initial Configuration tool to complete the preliminary configuration tasks, or if you do not want to copy the two configuration files to compute node 1, enter the necessary information manually.

      Go to Perform Initial Configuration.