Connect the Management Network
The SP network management port is labeled NET MGT. After the initial server configuration, you can connect to the SP over an Ethernet network using this NET MGT port.
If your network uses a DHCP server to assign IP addresses, the DHCP server assigns an IP address to this NET MGT port. With this IP address, you can connect to the SP using an SSH connection. If your network does not use DHCP, this NET MGT port is not accessible until you configure the network settings through the SER MGT port. For instructions, see Assign a Static IP Address to the NET MGT Port.
-
On the first compute node (compute node 1), connect a Category 5 (or better)
RJ-45 cable from the NET MGT port to the network switch or hub.
No.Description1Management network - For the second compute node (compute node 2), repeat Step 1 to make the same connections for that compute node to the management network.
- Connect the 10GbE client access network.