Remove the Rear I/O Module
The rear I/O module is a cold-service component that can be replaced only after you have powered off the server. For the location of the rear I/O module, see Rear I/O Module Port Locations.
 | Caution - This procedure requires that you handle components that are sensitive to electrostatic discharge. This discharge can cause server components to fail. |
- Take
the necessary ESD precautions.
See Prevent ESD Damage.
- Remove all of the power from the server.
- Locate the rear I/O module.
See Rear Panel Components (Service) for the location of the rear I/O module in the server.
- Label the cables connected to
the ports on the rear I/O module, and then disconnect the cables
from the ports.
You will reconnect the cables to the same ports on the replacement rear I/O module.
- Press the green buttons on the
rear I/O module ejection levers, and spread the levers open to eject
the rear I/O module.
- Pull the module away from the
server to remove it.
