Remove the Service Processor Card
The service processor card is a cold-service component that can be replaced only
after you have removed the main module.
| Caution -
This procedure requires that you handle components that are sensitive to
electrostatic discharge. This discharge can cause server components to
fail.
|
-
Determine your first step:
-
If you cannot access the service processor card, go to Step 2.
-
If you can access the service processor card, back up the SP
configuration information.
-> cd /SP/config
-> dump -destination uri target
where:
-
The acceptable values for uri are
tftp, ftp,
sftp, scp,
http,and https.
-
target is the remote location where you
want to store the configuration information.
For example:
-> dump -destination tftp://129.99.99.99/pathname
-
Take the necessary ESD precautions.
See Prevent ESD Damage.
-
Remove the main module from the server.
See Remove the Main Module.
-
Locate the service processor card on the main module.
See Main Module Internal Component Locations.
-
Grasp the service processor card by the two grasp points, and lift up to
disengage the service processor card from the connectors on the
motherboard.
-
Lift the service processor card up and away from the motherboard.