Go to main content

SPARC T5-8 Server Service Manual

Exit Print View

Updated: February 2019
 
 

Verify the Service Processor Card

  1. Ensure that you have completed the following:
  2. Verify that the SP LED on the main module or rear I/O module is lit green.

    See Front Panel Controls and LEDs or Rear Panel Controls and LEDs.

    If the SP LED is lit, see Diagnostics Process.

  3. Verify that the front and rear Service Required LEDs are not lit.

    See Interpreting LEDs.

    If the Service Required LED is lit, see Diagnostics Process.

  4. Log in to Oracle ILOM.

    See Log In to Oracle ILOM (Service).

  5. Start the faultmgmt shell.
    -> start SP/faultmgmt/shell
    Are you sure you want to start the faultmgmt shell (y/n)? y
    
    faultmgmtsp>
  6. Use the fmadm faulty command to determine if the server is operating normally.
    • If a fault was detected, see Diagnostics Process.

    • If no fault was detected, the SP was installed successfully.

  7. Verify that the SP date is correct.
    -> show /SP/clock
    
    /SP/clock
       Targets:
    
       Properties
            datetime = Tue Jan 01 23:15:59 1970
            timezone = GMT (GMT)
            uptime = 0 days, 00:01:18
            usentpserver = disabled
    
    Commands:
            cd
            set
            show
    
    ->
  8. Set the datetime property, if necessary.
    -> set /SP/clock datetime=MMDDhhmmYYYY
  9. Set the timezone property, if necessary.
    -> set /SP/clock timezones=3_to_4_characters

    where the timezone value equals a three or four character timezone abbreviation, such as EST or AHST.

Related Information