When PSH detects faults, the faults are logged and displayed on the console. In most cases, after the fault is repaired, the corrected state is detected by the server, and the fault condition is repaired automatically. However, this repair should be verified. In cases where the fault condition is not automatically cleared, you must clear the fault manually.
See Check for Faults.
In some cases, even though the fault is cleared, some persistent fault information remains and results in erroneous fault messages at boot time. To ensure that these messages are not displayed, type this PSH command:
faultmgmtsp> fmadm acquit UUID
In some cases, the output of the fmadm faulty command might include this message for the faulty component:
faulted and taken out of service.
If this message appears in the output, you must reset the server after you manually repair the fault.
faultmgmtsp> exit -> reset /System Are you sure you want to reset /System? y Resetting /System ...
Clearing a fault with the fmadm aquit command does not clear that fault in the Oracle Enterprise Manager Ops Center software. You must manually clear the fault (that is, incident). For more information, see 9.9.10 Marking an Incident Repaired in the Oracle Enterprise Manager Ops Center Feature Reference Guide at:
If you are servicing a component, return to the procedure for that component.
If you are upgrading the server, return to Server Upgrade Process.